搜尋結果
2024年8月6日 · Cover, Foreword, Content, List of Tables and List of Figures. Section 1 General. Section 2 Limit State Design Philosophy. Section 3 Materials. Section 4 Load Factors and Material Factors. Section 5 Serviceability Limit States. Section 6 Design Methods and Analysis. Section 7 Section Classification. Section 8 Design of Structural Members.
Standards commonly used for the design and construction of cladding works, which are acceptable to the Building Authority (BA), are given in Appendix A. On non-combustibility, the standards acceptable to the BA are given in section 5 of part E of the Code of Practice for Fire Safety in Buildings 2011 (FS Code).
- 111KB
- 10
Methods of test for masonry units. Part 1: Determination of compressive strength; Part 2: Determination of percentage area of voids in masonry units (by paper indentation); Part 7: Determination of water absorption of clay masonry damp proof course units by
It covers common retaining walls including conventional reinforced concrete walls, gravity walls (such as crib walls, gabion walls and mass concrete walls) and cantilevered retaining walls. 2. The first edition of Geoguide 1 published in 1982 advocated limit state analysis with global factors of safety.
Introduction. Bulk excavation, even if shallow, can be dangerous if not properly designed. Authorized persons, registered structural engineers (RSE) and registered geotechnical engineers (RGE) are reminded to take adequate precautions to ensure public safety whenever excavation is found necessary as part of the work.
A presumed allowable vertical bearing pressure of 100 kPa (if dry) or 50 kPa (if submerged) may be used for the design of footings _ of minor or temporary structures on flat ground and founded on granular materials. 3. Table 2.1 Notes Notes: (11) The use of
2024年8月20日 · The following tables contain the common conditions and requirements that may be imposed during approval and consent for specific structural materials/components and structural forms/construction methods and for enhancing site safety supervision as referred in Appendix A of PNAP APP-162 and circular letter dated 28 March 2024: