搜尋結果
6 天前 · Sika AnchorFix-1 has been specially formulated as a STANDARD-performance, two component adhesive anchor system. Sika AnchorFix-2 has been specially formulated as a HIGH-performance, two component adhesive anchor system. Sika AnchorFix-2 has more certifications as well, such as ANSI/NSF - 61 (portable water approval).
5 天前 · Once fully cured, SikaBond Construction Adhesive is waterproof and it can be fully submerged. It will remain flexible and absorb movement.
2024年8月3日 · The industry standard for sealing joints in green or new concrete is 28 days, however with the Sikaflex+ range of products, joints can be filled after a 24 hour cure. The Sikaflex+ range can also be applied on concrete that is wet, one hour after the water source has stopped.
2024年8月2日 · Yes, you can use Sikaflex Crack Flex Sealant for your application. Please note that if the hydrostatic pressure is great, the sealant may fail. This would be the result with any sealant. The minimum depth and width requirement of the crack must be at least 1/4" x 1/4". If the crack does not meet this requirement, you can use a chisel and hammer to widen it. Properly prepare the crack before ...
3 天前 · Sikadur Crack Fix can be used in hairline cracks with a maximum crack width of 1/4". If the crack is too deep, the epoxy will simply seep into the crack and not preform well. You can apply sand to limit the depth, but it is important to avoid dust, which will jeopardize the bond.
5 天前 · Posted August 2, 2024 by Sika Expert. If the joint is deep or very narrow (past the 1/2 inch depth limitation), the sealant will travel down pushing air out. Most bubbles will pop but if they reach the surface when the sealant is "skinning" over, they will not burst.
2024年7月29日 · Yes Sikalfex Concrete Fix can be painted with an epoxy floor based on the manufacturer recommendations. Do not use coatings which have high solvent content. It can be painted after a full cure (5 to 7 days). One thing to note is that the sealant will flex if there is movement in the slab.
