搜尋結果
- Yahoo字典IPA [ɪˈpɒksi]
adj 形容詞
- 1. 環氧的 epoxy cement 環氧水泥
vt 及物動詞
- 1. 用環氧樹脂膠合
Powered by Oxford Chinese Dictionary
2021年11月1日 · While I'm waiting for my tabletop to fully set I'm thinking how I'm going to attach the legs to my tabletop. I attached a pic of what I'm working on. I would love to use treaded insert to bolt on the steel legs but I'm not sure if you can use those in epoxy. I'm afraid to crack the top and not sure if those would cut its
2007年6月30日 · Epoxy is supposedly better for gap filling (which is great for some of my joints) and one doesn't have to clamp like for Titebond. But I do know from reading and personal experience that epoxy is more susceptible to breaking from shock. I don't like the fact that the epoxy broke at the glue joint.
2017年1月15日 · I would use Doug's approach. With the wood shown in the pic you're going to get some bleed and discolouration no matter what method you use and whether the epoxy is tinted or not. As Jim mentioned it soaks into wood and its because of this its used to stabilize wood that is in a state of decay.
2020年8月7日 · Have knots in cutting board project and in charcuterie board project. Want to fill them, local woodworker says to use epoxy and black pigment. All kinds of answers on google, ranging from "epoxy is food safe" to "only some are" to "Are you okay with eating small chunks of epoxy". Tried searching
2020年2月22日 · Hi All, I recently completed this table for my home and on other projects throughout my home I used Rubio Monocoat to make the wood grain pop. My plan was to use Rubio Monocoat on this table then epoxy flood coat the top to seal the wood. Will the Rubio Monocoat effect the epoxy resin and would the Rubio Monocoat even be
2021年3月9日 · Alumilite Clear Slow - is a poly-urethane resin that should be cast under pressure, to reduce any small bubbles to un-noticeable. It all depends what it is you want to make. Personally I use Alumilite Clear Slow, and I have a Princess Auto Pressure Pot. I let my blanks sit for at least 1-2 hours at 60psi.
2019年12月11日 · I am working on two night tables right now. The drawers will run on wood slides. Unfortunately one slide needs a hole drilled into a knot and worse luck it is just at the edge of the knot so the knot basically disintegrated enough there will be no purchase for the screw. I thought about filling with epoxy and re-drilling. I
2019年1月8日 · 01-09-2019, 02:01 PM. To avoid bubbles make sure the freshly epoxied piece is cooling down not warming up. In other words, don't turn the heat on in the shop a half hour before making the pour then leave it on continuing to warm the piece as you try and get the epoxy to harden. That'll drive air out of the wood.
2021年10月2日 · I recently finished a cherry wood coffee table with Osmo. I put on a couple coats and noticed that from certain angles and with bright light that there is some streaking. From most angles it looks perfect, but from other angles it's not great. I think part of the problem was that I didn't wipe it down enough after applying.
2007年11月12日 · 11-13-2007, 07:55 AM. Problem with glueing plywood faces together is that you introduce moisture to one side of the sheet and not the other. We all know what happens then. to prevent this attack of the swelling wood fibers, I would suggest you laminate with contact Cement similare to laminating Formica.
