搜尋結果
3 天前 · 用來造型果隻(有大枝主劑+細枝硬化劑, 用法同原子灰一樣)叫 polyester putty, 台灣叫"寶麗畢地", 香港叫造形畢地. 好多時模型舖入面係根本冇人識同會去砌模型既. d 名一早就俾佢地搞到亂晒.
2024年5月17日 · 註冊 2018-4-8. 狀態 離線. #1. 只看樓主. 發表於 2018-4-26 11:10 PM 資料 短消息 加為好友. 求助 人型figure上色後，需要油/噴保護漆嗎？. 各位ching，小弟真係新手中的新手，最近用 tamiya epoxy做了一個人型，之後上了雙星xf油。. 想請問要不要再上保護漆的呢？.
2024年5月9日 · Tamiya zimmerit stickers are kinda meh. They work fine on flat surfaces, but are really bad on curved surfaces and u need to use CA glue to glue anything to them. I had best results with epoxy putty (Tamiya Epoxy Putty, Magic Sculpt, etc.) and special tools
2024年5月11日 · Take some getting used to working with putty. Normally I use small amounts with some water. The video on the link will give an idea how I made this figure https://www.youtube.com/watch?v=sq8li-kEK6U
2024年5月16日 · - First prepare a small piece of mixed Tamiya epoxy putty. - Retrieve a tiny piece from the mix and put it on a hard surface under a steel ruler. - Put your fingers on the ruler and start moving it back and forth. Do not put too much pressure on the ruler. After a few
2024年5月1日 · Moderators: BB62vet, MartinJQuinn, JIM BAUMANN, Jon, Dan K. Hi all, well after build my first ship model around 9 years ago (1/350 Hasegawa Nagato) I have the taste for it again. Too be honest I haven't done much modeling for around 3 years and am just getting back into it. I picked up the new tool Tamiya Yamato kit with a few extras last week ...
6 天前 · Thank you, the steel texture was done by stippling Mister Surfacer 500 over the model with a hard brush and the weld lines are made from Tamiya epoxy putty. The link explains it way better then I could
